When the fireplace will burn continuously more than 4 hours, or you will use it before bedtime, you
need to ventilate the room briefly but intensely.
In case of fire, use a powder or foam extinguisher. If you do not have a fire extinguisher, use a wet
cloth to extinguish.
Bio-ethanol can remain in the burner and be covered by the cap but only temporarily.
For fireplaces that use torch buds or beakers as a burner (ex: type Gijon, Sladana, Paradise, etc.) it is
necessary to check before use whether the cup is cracked or damaged. In the case of any damage the
fireplace can’t be used and the torch cup burners or beakers must be replaced as soon as possible.
Concerning the hanging fireplaces such as Max Kamin and those with similar dimensions and sizes,
you must not use accessories such as decorative logs and stones.
Failure to comply with the directions for use could cause a fire.
The fireplace must not be used without the supervision of knowledgeable, instructed persons. In
case you need to leave the room, turn off the fireplace and light it again when you return.
The fireplace can be operated only by persons over 18 years and who have read the manual. During
use of the fireplace in the room there must not be children or other unauthorized persons without
the supervision of the operator, to prevent accidental manipulation of the fireplace or accidental
placement of other objects that could get near the heat of the fire.
Due to the large temperature fluctuations of use, from about 20 degrees to 600 degrees and then
back again, be aware that it can lead to various stresses and subsequent stretching of the material.
With such a large change in temperature it is a normal that various parts of the fireplace can warp
and slightly defect the burner inserts and so on. Warping or bending is ok, but make sure it does not
cause cracks. The only problem would be if a crack appeared at the mouth or in any part of the
burner. At this point, immediately discontinue the use of the fireplace, turn off the fire with a
blanket, or reduce the supply of oxygen another way because the fuel could spill and spread the fire
rapidly.
To clean the stainless steel parts you can use common cleaning products, except for products that
contain abrasive particles that could damage the surface of the fireplace. For cleaning the painted
surfaces, use products for that purpose. The damage caused by inappropriate chemical cleaners or
aggressive substances is not covered by warranty.
After any contact with bio-ethanol wash your hands thoroughly with soap and water, especially
before eating.
It is only allowed to burn the bio-ethanol that is designated for it. Always keep the
Bio-alcohol away from reach of children and in original packaging with the label on and out of
sunlight and any other heat sources.