ETT EPH-40 Скачать руководство пользователя страница 4

599-604 

ETT Distribution GmbH Schmalbachstraße 16 38112 Braunschweig Nachdruck oder Vervielfältigung nur 

mit ausdrücklicher Genehmigung Stand 02/ 2019 

 

 

 

Function: 

 

1.

 

Piston with spring. 

2.

 

Release. 

3.

 

Heatable nozzle. 

 
 

 
 
 
 
 
 
 

 
 

 
 
 

 
 
 
 
 
 
 

 

 

Cleaning the Device and Exchange of the Nozzle: 

 

 

The sucked in brazing solder will be gathered in the working 

chamber of the cylinder and can be ejected by pressing the 

piston again. 
After a longer period of using it is recommended to remove 
the solder leftovers from the working chamber. 

Press the piston down and lift the complete cylinder out of 

the device. 
Remove the piston and the spring from the working chamber 
and clean it. 

Afterwards insert spring and piston back into the working 

chamber. 
Now attach the whole cylinder to the device. 

In case the nozzle is too polluted unscrew it and replace it 

with a new one. 

Содержание EPH-40

Страница 1: ...Inbetriebnahme das Gerät auf Beschädigungen sollte dies der Fall sein bitte das Gerät nicht in Betrieb nehmen Ziehen Sie den Netzstecker wenn Sie das Gerät längere Zeit nicht benutzen Das Gerät keinen mechanischen Belastungen oder Feuchtigkeit aussetzen Das Gerät wegen der Durchlüftung nicht abdecken und vor direkter Sonneneinstrahlung schützen Reinigen Sie das Gerät nicht mit einem scharfen Reini...

Страница 2: ...es Drücken des Kolbens wieder ausgestoßen Nach längerer Gebrauchsdauer sollten die Lotreste aus dem geöffneten Gerät entfernt werden Drücken Sie den Kolben herunter und heben Sie den kompletten Zylinder heraus Jetzt kann man den Kolben und die Schraubfeder aus der Arbeitskammer entfernen und diese reinigen Fügen Sie anschließend die Feder und den Kolben wieder in die Arbeitskammer ein Setzen Sie d...

Страница 3: ...he device please check it for any possible damages In case of damage do not operate it Unplug the device or remove the batteries if you do not use it for a certain time The device may not become subject of mechanical stress and should not be exposed to humidity To be considerate of the ventilation do not cover the device and protect it from direct solar radiation Do not clean the device with corro...

Страница 4: ...orking chamber of the cylinder and can be ejected by pressing the piston again After a longer period of using it is recommended to remove the solder leftovers from the working chamber Press the piston down and lift the complete cylinder out of the device Remove the piston and the spring from the working chamber and clean it Afterwards insert spring and piston back into the working chamber Now atta...

Отзывы: