ETS-Lindgren EMI, Руководство по установке и обслуживанию

Страница: 12 / 22

12
ENVIRONMENTAL SPECIFICATIONS
Attribute Operating Non-Operating
Temperature -45° C to + 65° C -55° C to +85° C
Altitude Sea Level to 8,000 ft Sea level to 40,000 ft
Humidity Relative humidity between 10% and
90% at air temperatures between
+25° C and +32° C Relative humidity as low as 14% at an
air temperature of +71° C and as high
as 100% at temperatures from -33°
C to +33° C with condensation at all
temperatures lower than +30° C
INSTALLATION
Uncrate all parts. Check all parts for any shipping damage. Ensure adequate space is available for installing the filter.
Do not discard any packaging material until the unit is installed.
Electrical connection should only be performed by a qualified electrician and in compliance with all
applicable regulatory agencies.
Connection to the filter should be made by qualified electricians. Refer to the TERMINATIONS section for
further details.
Wiring should be done in accordance to the wiring schematic provided in the ILLUSTRATIONS section of this manual
and applicable local and national electrical codes and guidelines.
Installation of the conduit penetration and EMI gasket should be done in accordance with the drawing provided in the
ILLUSTRATIONS section of this manual.
POWER ON
Prior to applying power to the filter, verify wiring is correct. Use an ohmmeter to verify there are no shorts
from any line to ground or neutral.
Electrical wiring verification should only be performed by a qualified electrician and in compliance
with all applicable regulatory agencies.