Model 5225 Series Shielded Enclosure
© Copyright 2008–2010 by ETS-Lindgren L.P. All Rights Reserved. No part of this document
by any means without written permission from ETS-Lindgren L.P.
may be copied
The
logo is a trademark of ETS-Lindgren L.P.
ETS-Lindgren
399296, Rev B
USA Headquarters
1301 Arrow Point Drive
Cedar Park, TX 78613
Phone: (512) 531-6400
[email protected]
Please see
f
www.ets-lindgren.com
or a list of all ETS-Lindgren offices.
Safety Information
Warranty Information
For warranty information, see the
.
Product Information Bulletin
ONLY QUALIFIED PERSONNEL
should install, operate, or service this equipment.
CONTACT ETS-LINDGREN PRIOR TO SERVICING.
Servicing (or modifying) the unit by yourself
may void your warranty. If you attempt to service the unit by yourself, disconnect all electrical power
before starting. There are voltages at many points in the instrument that could, if contacted, cause
personal injury. Only trained service personnel should perform adjustments and/or service procedures
upon this instrument. Capacitors inside this instrument may still be CHARGED even when instrument is
disconnected from its power source.
WARRANTY
For complete safety information, see the
.
Product Information Bulletin
Revision/Date:
B, Adjust graphics, add specifications - October, 2010
A, Initial Release - September, 2008
www.ets-lindgren.com
www.ets-lindgren.com
The following views and setup instructions apply to a standard configuration of the
. Components may vary for custom
Model 5225 configurations. Contact ETS-Lindgren for questions regarding your configuration.
ETS-Lindgren Model 5225 Series Shielded Enclosure
IEC power connector
Lid handle
(on front)
Front, Right Side
Antenna patch with
SMA connectors
Front, Left Side
Back View
Antenna patch with
SMA connectors
Location for
equipment under test
(EUT)
Inside View
Filtered DB-9
feedthrough
Fiber optic
feedthrough
