GSM Gateway ETS-16G User
’s Manual
Shenzhen Etross Telecom Co.,Ltd
22
BCCH roam
To set BCCH roaming if you enable it on
Valid Dbm
To set the base station dbm value,if the value is more than this
value,the base station will not accept Bcch roam, only the value is less
than this value, it will roam to this base station
Roam cycle
To set rotate/cycle after specified minutes .e.g.10 minutes means rotate
to next base station after 10 minutes.
BCCH list
Means you can input the BCCH list in the blank, then the base station
roam will do in these BCCH list . You can get the BCCH list parameters
from the Status\BCCH
Save
To save the setting
white
To permit the BCCH roam in these specified BCCH list
Black
To permit the BCCH roam in other BCCH list expect the specified BCCH
list
4.4.2 Batch setting
To do batch setting of ports, you can do the setting in one time if all the ports setting parameters
are same.
Figure 4-4-2-1 Batch setting
Table 4-2-2-1 Description batch setting
Port batch setting
To set all the 16 ports parameters in one time
Port enable
Means we can choose to open or close the port (On / Off)
Trunk number
To specify the Trunk to use for this port
Port type
Call in type: IVR or hotline for selection
SIM-PIN
SIM pin setting and the PIN code number to be inputted
Speaker Volume
To set the speaker’s volume value
Microphone sensor
To set the microphone’s sensor value
Hide caller ID
To hide the outgoing caller’s ID ( Need carrier’s support),default is off
Call in forbidden
To forbid call in, default is off