Eton ATV RXL 50, Руководство по обслуживанию

Страница: 9 / 66

2.6 AIR CLEANER
Unscrew the air cleaner cover screws.
Pull out the air filter element from the air cleaner case.
Wash the element in non-flammable solvent, squeeze
out the solvent thoroughly.
Let it dry.
Soak the filter element in gear oil and then squeeze
out the excess oil.
Install the element into air cleaner carefully.
2.7 SPARK PLUG
This spark plug located at the front of the engine.
Disconnect the spark plug cap and unscrew the spark plug.
Check the spark plug electrodes for wearness.
Change a new spark plug if the electrodes and insulator tip
appear unusually fouled or burned.
Discard the spark plug if there is apparent wear or if the
insulator is cracked or chipped.
The spark plug gap shall keep in 0.6-0.7mm.
With the sealing washer attached, thread the spark plug in
by hand to prevent cross threading.
Tighten the spark plug with 12-19 N.m
2.8 IDLE SPEED
Connect an engine speed meter.
Warm up the engine, 10 minutes are enough.
Turn the idle-speed adjust screw on the carburetor
to obtain the idle speed. “Turn in” (clockwise) will get higher
speed. “Turn out” (counter clockwise) will get lower speed.
IDLE SPEED: 1800±100 rpm
2.9 DRIVE CHAIN
Inspect the chain slack.
The standard is 10-25mm.
8