ETNA KKV655 Series, Инструкция по эксплуатации

Страница: 103 / 108

EN 25
Faults table
When you have any doubts about whether your appliance is working properly you should not
immediately assume that it is defective. We recommend that you should in any case check the
points in the following table.
Symptom Possible cause Solution
The appliance emits a slight
odour when used for the first
time. New appliance. This is normal and disappears
when the appliance starts
cooling.
The appliance does nothing;
the lighting does not come
on. Plug not in socket. Insert the plug in the socket.
Thermostat off. Adjust the thermostat to the
correct setting.
Temperature inside the
appliance too high or too low. Thermostat setting incorrect. Adjust the thermostat
properly.
The door seals are dirty or the
seals are damaged. Clean the door seals. Call
the service centre if the door
seals are damaged.
Water runs from the
refrigerator. Defrost water drain clogged. Clean defrost water drain (see
"Defrost").
Appliance makes a noise. Incorrect positioning of food
in the appliance. Place foods in the proper
manner in the appliance.
There is an object against the
appliance. Remove the object.
The LED lighting does not
work. LED-lamp faulty. Consult a service technician
about LED lighting that is not
working. For safety reasons,
you are not allowed to repair
LED lighting yourself
Ice building up. Door frozen compartment not
closed properly. Make sure that the door is
closed properly.
Frozen compartment is not
periodically defrosted. Defrost the frozen
compartment to remove the
ice.
The door seals are dirty or the
seals are damaged. Clean the door seals. Call the
service centre if the door seals
are damaged.
FAULTS