ETNA FGV150 Series, Инструкция по эксплуатации

Страница: 37 / 52

EN 13
Operating the hob
1. Push in the control knob and turn it to the left to the high setting.
2. For FGV150: push the knob for manual spark ignition until the burner ignites.
The burner will ignite.
▷ The control knob should be pushed in and held for about 10 seconds because of the
flame safeguard.
▷ The gas flame can be smoothly adjusted from high to low. If the burner fails to light after
repeated attempts, check to ensure that the burner cap is properly positioned.
0 position
High setting
Low setting
Burner zone
In case the flames are accidentally put out, turn the knob to the “off” position, wait for
60 seconds and re-ignite the burner again as described.
If the burner fails to ignite or doesn’t stay on, check that:
• the burner cap and burner ring are seated correctly in the burner housing;
• the burner/spark plug and thermocouple are clean and dry.
Ac: Burner spark plug
Tc: thermocouple
OPERATION