ETNA FEV150WIT, Инструкция по эксплуатации

Страница: 33 / 40

EN 15
INSTALLATION
General
A registered installer should only connect this appliance. The electrical connection must
comply with national and local regulations.
Read the separate safety instructions first!
Note!
• This appliance must be earthed at all times.
• Installation, maintenance or repairs should only be carried out by professionals who are
authorised by the manufacturer, as failure to do so will void the guarantee.
• The device should be disconnected from the mains prior to installation, maintenance or
repairs. The device is only disconnected from the electric power if:
▷ the main switch of the domestic electrical system is switched off;
▷ the fuse of the domestic electrical system has been completely removed;
▷ the plug has been pulled out of the socket.
• Faulty parts may only be replaced with original Etna parts. Only these parts are guaranteed
by Etna to meet the safety requirements.
• If the connecting cable is damaged, it may only be replaced by the manufacturer, the
manufacturer’s service organisation or equivalently qualified persons, in order to avoid
dangerous situations.
Electrical connection
230V~/400V 3N~ - 50/60 Hz
The electrical connection must comply with national and local regulations. For the
Netherlands this includes the NEN 1010 amongst other standards.
• The wall plug socket and plug should always be accessible.
• Make sure that the cable does not come into contact with parts of the oven that may
become hot.
• If you want to make a fixed connection, make sure that an omnipolar switch with a contact
separation of at least 3 mm is fitted in the supply cable.
• The appliance should not be connected to the mains via a multiplug adapter or extension
cable, as the safe use of the equipment cannot be guaranteed.
• The fused switch must be easily accessible once the appliance has been installed.
• Ensure all connections are adequately tightened.
• Fix the supply cable in the cable clamp and then close the cover.
• The label showing the wiring diagrams is placed on the terminal box.