ETNA EWM246KWIT, Инструкция по эксплуатации

Страница: 18 / 32

452515
• Insert the fi lter back as shown on the picture, and tighten by
turning it in clockwise direction. To ensure good sealing the
gasket surface (A) must be dirt free.
The washing machine automatically monitors the execution of particular functions during the
operation, and reports any detected failures.
In such cases signal LED’s start
fl ashing in certain sequence.
The fl ashing sequence changes in accordance with the nature of the detected failure.
In some cases you may attempt removing certain failures yourself, so count the number of fl ashes,
repeating after certain pauses.
The machine signals failures immediately after detecting them and stops the program, except for
heater failure, where the machine completes the washing program without heating water.
Failures:
2 - Two
fl ashes: door is not correctly closed
3 - Three fl ashes: inappropriate water intake
7 - Seven fl ashes: inappropriate water outlet.
In these cases, you will be able to remedy the failure by yourself (See Troubleshooting table).
1 - One fl ash: temperature sensor failure
4 - Four fl ashes: spinning sensor failure
5 - Five fl ashes: motor failure
6 - Six fl ashes: Heater failure
In these cases, turn off the machine, then turn it back on and repeat the program. If the failure
reoccurs, contact your nearest authorized service center. The LEDs will continue to
fl ash until the
machine is turned off.
Interferences from the ambient (for example electrical wiring) could induce signalization of different
faults. In such cases:
- switch the appliance off, and wait for a few seconds;
- switch the appliance back on and repeat the washing program.
If the fault repeats, call authorized service shop.
Warranty shall not apply in case of failures due to interferences from the environment (lightning
stroke, power supply circuit faults, natural disasters).
18
Failures