ETNA EVW8261, Руководство пользователя, Страница: 22 / 31

WATER SOFTENER
Loading salt into the softener
(The container must always be filled)
1.
Remove the lower basket and then unscrew and remove the cap from the container.
2.
If you are filling the container for the first time, fill 2 Ú
3
of its volume with water.
3.
Place the end of the funnel (supplied) into the hole and introduce about 1.2 kg of salt. It is
normal for a small amount of water to come out of the salt container.
ATTENTION: Remove spilt salt and start a washing program immediately to prevent
damage to the bottom of the diswasher.
4.
Carefully screw the cap back on.
ATTENTION:
The salt container must be refilled when the salt warning light in the control panel comes on. Though the salt
container is filled enough, the indicator light may not black out before the salt is fully dissolved.
Adjusting Salt Consumption
1.
Unscrew the cap from the salt container.
2.
There is a ring on the container with an arrow on it (see figure to the side), if necessary, rotate
the ring in the anticlockwise direction from the “-”setting toward the “+” sign, based on the
hardness of the water being used. It is recommended that adjustments should be made in
accordance with the following schema:
Contact your local water board for information on the hardness of your water supply.
This appliance is equipped with a water softener.
20
Always use salt intended for use with dishwasher. The salt container is located
beneath the lower rack and should be filled as follows:
You can adjust the amount of salt consumed based on the hardness of the water used.
Proceed as follows:
WATER HARDNESS
ºClarke
0 - 10
10 - 28
28 - 56
>56
ºdH
0 - 8
8 - 22
22 - 45
>45
mmol/l
0 - 1.4
1.4 - 3.9
3.9 - 8
>8
selector position
/
-
Mid
+
salt consumption
(gram/cycle)
0
20
40
60
autonomy
(cycles/2 kg)
/
50
25
16