EN 15
Removing the glass panel
The inner panel can be removed for easy cleaning of the glass panel.
• Remove the oven door.
• Slide the glass panel and frame upwards out of the oven door.
Note!
The glass panel can also be removed when the door is fitted to
the oven. In this event, do ensure that the hinge springs do not cause
the door to slam unexpectedly.
Replacing the oven lamp
• Remove the runners.
• Remove the glass cover (V) of the fitting by placing a screwdriver
between the cover and the oven wall.
• Replace the lamp (L)
Fit a new lamp with the following specifications:
15W/230V ~ 50Hz - 300°C (E14).
• Replace the glass cover.
In the event of stubborn stains, the following should be observed:
The oven should be cooled down before cleaning.
• Clean the oven and the accessories after each use, to prevent the
dirt from burning into the oven.
• The easiest way to remove grease is by using warm soapy water
while the oven is still warm.
• For very stubborn dirt, use conventional oven cleaners. Make sure
to thoroughly rinse the oven afterwards with clean water to remove
any residual cleaning agent.
• Never use aggressive cleaning agents such as steel wool, scouring
pads, stain removers etc.
• Varnished, stainless steel, and galvanised surfaces, and aluminium
parts must never come into contact with oven sprays, because this
will damage and discolour them.
The same applies to the thermostat sensor (if the device is equipped
with a timer with a sensor), and to the heating elements that are
accessible at the top.
• When purchasing and using cleaning agents, be sure to take account
of the environment and heed the instructions of their manufacturer.
MAINTENANCE
