Page 5 of 8
For Support C61-2-9956-7377
Or
Etm9420_9440_Quick_Start_Guide
201705RV01
Antenna
The ETM9420-1/9400-1 Terminal has a standard FME Jack (Male) antenna Plug on the end of an
approximately 90mm cable.
SIM Card
The SIM card connector is located on the underside of the ETM9xxx (x) Terminal. The unit
supports both 3V and 1.8V SIMs. Any SIM card used needs to be correctly provisioned for the
services and network upon which it is intended to be used.
If the terminal is intended to be used for remote access to a device a terminating data number for
Circuit Switch Data (CSD) will need to be provisioned by the network operator, this number will
usually differ from any voice/SMS number. Other key configuration settings are;
◩
Telstra NextG® SIMs to be used for CSD require 2620 bearer capability
SIM Pin
If the SIM used has a PIN either;
The device connected to the modem needs to enter the SIM pin using the appropriate AT
command
OR
The SIM PIN should be deactivated, insert the SIM in a mobile phone and deactivate then
transfer the SIM to the ETM9420-1/9440-1
Caution
Always disconnect power supply before
inserting or removing SIM Card.
Care should be taken in inserting and
removing the SIM card so as not to
damage the SIM holder or cover.
FME M Antenna Connector
