eTIGER S3 Sim Secual, Руководство пользователя

Страница: 10 / 12

18 19
Housing material
ABS plastic
Operating temperature
-10°C~55°C
Relative humidity
≤80% (non-condensing)
Transmitter dimensions (LxWxH)
71 x 34 x 17.5 mm
Magnet dimensions (LxWxH)
51 x 12 x 13.5 mm
Wireless PIR Motion Detector
Features
ES-D1A (or ES-D2A: Pet-Immune Motion
Detector) is a high performance wireless
P.I.R. motion detector. It boasts a digital
dual-core fuzzy logic infrared control chip
with intelligent analysis. This technology
identifies interferences created by body
motion and reduces the false alarm rate.
With automatic temperature compensation
and anti-air turbulence technology, it easily
adapts to environmental changes.
3
1
2
1. LED indicator
2. Detection window
3. Bracket
LED indications
Blinks continuously: self-testing
Blinks once: an intruder is detected
Blinks twice: self-testing is complete; entering
working mode.
Blinks once every 3 seconds: under-voltage
indication: the batteries must be replaced.
(The user will be informed by SMS when the
batteries are low if the PIR Motion Detector is
registered in the control panel.)
PCB Layout
Alarm zone setup
Tamper switch
Infrared sensor
AA 1.5V LR6
Antenna
LED working indicator
Infrared sensor
Detects the infrared rays released by human
body motion. Do not touch the surface. Keep
the surface clean.
Tamper switch
When the alarm system is armed, the tamper
switch will trigger the alarm if the case is
opened.
Usage
Open the case and remove the battery
activation strip to activate the batteries. Self-
testing will start for one minute.
Mode Setting
Test Button
Testing mode
Once the self-testing is complete, press the
test button. The sensor switches to testing
mode, and scans once every 10 seconds.
After 3 minutes, the LED blinks twice, and
the sensor switches to working mode.
Working mode
In working mode, if the sensor is triggered
more than twice within 3 minutes, it will
switch to standby mode to save power. If
a movement is detected within the next
3 minutes, the standby mode is extended
by 3 more minutes. If no movement has
detected within these 3 minutes, the
detectors turns back to working mode.
Register in the control panel
Press the Connect button { } on the control
panel. Press the test button of the sensor
twice. The control panel beeps once: the
motion detector is registered.
To check if the registration is complete, arm
the system and trigger the sensor again.
If the siren rings out, the registration is
successful.
Installation
Avoid mounting the detector close
to windows, air conditioner, heater,
refrigerator, oven, sunshine and places
where the temperature changes fast or
where the air stream flows frequently.
If two detectors are installed in the same
detection scope, adjust the location to avoid
interferences and false alarms.
Top
Bottom
Ground
2.2 m
Side view
Top view
Fix the bracket on the wall with screws and
attach the detector to the bracket. Adjust
the bracket to change the detection distance
and angle. It is recommended to mount the
detector 2m from the ground.
The detector is more sensitive to cross
movements than vertical movements.
Testing
A. After one minute of self-testing, press the
test button, walk in the scope of detection
and watch the LED indicator to make sure the
detector is working.
B. The LED indicator blinks once when body
movement is detected.
C. Adjust the detector angle to achieve the best
detection performance.