6
7
www.ETiSSL.com
Please contact 1-855-384-7754 or further assistance.
installation (continued)
Care and Cleaning
CaUtion:
Before attempting to clean the fixture, disconnect the power to the fixture by turning the breaker off or removing the fuse from the
fuse box.
□
Clean the fixture with a soft, dry cloth.
□
Do not use cleaners with chemicals, solvents, or harsh abrasives.
□
Do not use liquid cleaner on the LEDs, LED driver, or wiring inside the light fixture.
troubleshooting
WarninG:
Before doing any work on the fixture, disconnect power to the light fixture.
Minor problems often can be fixed without the help of an electrician.
Problem
Possible Cause
Solution
The fixture will not light.
The power is off.
Ensure the power supply is on.
The circuit breaker is off.
Ensure the circuit breaker is in the on position.
There is a bad connection.
Check to ensure proper wire connections are made.
Contact a qualified electrician.
There is a defective switch.
Contact a qualified electrician.
The fuse blows or the circuit breaker
trips when the light is turned on.
The wires are crossed or the power
wire is grounding out.
Check the wire connections.
Contact a qualified electrician or call customer
service 1-855-384-7754.
7
Securing the lens cover to the
fixture plate
□
Rotate the lens cover (B) up to align the two screw
holes at the top of the lens cover (B) with the screw
holes at the top of the fixture plate (A).
□
Tighten the screws until the lens cover (B) is secure.
□
Restore power at the electrical panel.
□
Turn on the light switch to activate the fixture.
B
8
Using silicone sealant between the
wall and the fixture plate
□
To ensure a watertight seal, apply silicone caulk (not
provided) around the back edges of fixture plate (A).
A
B
A