F
Green
White(N)
Black(L)
G
C
F
H
A
G
Model # 51405143, 51405144
Part # SC-2HD-2400LM-8-40K-SV-BZ, SC-2HD-2400LM-8-40K-SV-W
Certification # 51405143, 51405144
USe anD Care GUiDe
2 HeaD LUMen BooSt DUSK to DaWn SeCUrity LiGHt
note
:
Keep your receipt and these instructions for proof of purchase.
WarninG
:
Shut off the power at the circuit breaker or fuse panel before removing the old fixture,
ballast, or fluorescent tubes.
If you are unfamiliar with electrical installations, we recommend you contact a qualified electrician to
do the installation.
INSTALLATION
This light fixture is suitable for wall mounting or eave mounting only. It is not suitable for ground
mounting installation. The light fixture should be mounted a minimum of 6.5 ft. (2.0 m) above the
ground. If two walls intersect, than the distance between the intersecting line and the light fixture
should be more than 2 ft. (0.6 m).
Shut off power at the electrical panel before beginning the installation.
Remove existing fixture and set aside to recycle in accordance with local requirements.
Choose the desired brightness (lumen output).
notiCe:
The factory setting for the brightness (lumen output) is 2400lm.
Attach the mounting bracket (G) to the electrical box using the
two short mounting screws (C). The stamped word “GND” faces
away from the electrical box during the installation.
4
5
PAckAge cONTeNTS
Part Description
Quantity
A Fixture
1
B Mounting Screw (long)
1
C Mounting Screw (short)
2
D Grounding Screw (green)
1
E Rubber Plug
1
F Wire Connector
3
G
Mounting Bracket
1
H
Foam Gasket
1
I
Rubber Cover
1
1
2
Connect the hot and neutral (black and white) wires from the light
fixture (A) to the same color wires from the electrical box.
Connect the ground wire from the light fixture (A) to the ground
wire from the electrical box, then attach the ground wire to the
grounding screw (D) on the mounting bracket (G).
Cover the wire connections using the wire connectors (F).
6
Position the foam gasket (H) between the electrical box and the back of the light fixture (A) to create a
weathertight seal.
Pull the wires from the electrical box through one of the two openings in the foam gasket (H).
8
Apply silicone sealant (not included) to
the edges of the light fixture (A) so that
the fixture can be completely waterproof
and dustproof.
Move each light head into the desired
position with your hand, as needed.
NOTe:
Do not mount the photocell
sensor in the down position.
Install the light fixture (A) to the mounting
bracket (G) using the mounting screw (long)
(B) provided, making sure no wires are visible
outside the light fixture (A).
Insert the rubber plug (E) into the hole on the
light fixture (A) for a finished appearance.
9
3
A
B
C
D
E
H
G
I
7
H
G
G
A
H
E
A
C
A
