ETI 50232162, Инструкция по использованию и уходу, Страница: 3 / 25

4
5 ETiSSL.com
Please contact 1-855-384-7754 for further assistance.
suspension Mounting
1
Removing the power supply box
□
Remove the four screws that attach the power supply box to the LED fixture body (A) using the power tool hex bit (FF).
□
Put the screws aside as they will be needed to reattach the power supply box to the fixture body (A) in a later step.
□
Lift the power supply box from the fixture body (A) and unplug the Quick Connect wires.
Quick
Connect
Knock-out Hole
Power Supply Box
A
A
Power Supply Box
Power Supply Box
Power Supply Box
A
Quick
Connect
A
Power Supply Box
2
Preparing the power supply box for wiring
□
Remove the knock-out near the end of the power supply box.
□ Fit a 1/2 in. snap-in bushing into the knock-out hole.
□
Feed the wiring out through the bushing and knock-out hole.
□
Reconnect the two ends of the Quick Connect wires.
□
Align the screw holes in the fixture body (A) with the screw holes
in the power supply box.
□ Fasten the fixture body (A) to the power supply
box with the previously removed screws, using the
power tool hex bit (FF).
suspension Mounting (continued)
3
Mounting to drywall
□ Drill two holes large enough to clear the closed flaps of the
butterfly nut on the toggle bolt (not included).
□
Fasten the toggle bolt into the butterfly nut before
inserting the flaps into the ceiling.
□
Tighten the toggle bolt.
installation
WarninG:
RISK OF ELECTRIC SHOCK. Ensure the electricity to the wires you are working on is shut off. Either remove the fuse or turn off the
circuit breaker before removing the existing light fixture or installing the new one.
With power disconnected to the electrical box, remove the existing fixture. Make a sketch of how the current fixture is wired (by wire color)
or mark the wires with masking tape and a pencil so you will know how to properly reconnect the wires to the new LED light fixture.
4
Mounting to wood
□ Drill two 1/16 in. diameter holes in the ceiling to
accommodate hook screws (not included).
□
Fasten the combo wood-machine end into the metal hook.
□
Tighten the hook screw (not included) into the wood.
FF
FF
AA
DD
EE FF
BB
CC
Pre-installation (continued)
HARDWARE INCLUDED
nOTe: Hardware not shown to actual size.
Part Description Quantity
AA Cover Plate 1
BB Cable Set 2
CC Chain with S-Hook 2
DD Electrical Box Screw 2
EE Wire Connector 3
FF Power Tool Hex Bit 1