EX17908 Web-Smart Switch Installation Guide
Copyright 2020 EtherWAN Systems, Inc.
Page 2
All Rights Reserved
E
X17908
02/25/2020
W70G-E17908XQ2
F.
At the Web management interface, click
Configuration > System
.
G.
At the System Configuration page:
-
If your network uses a DHCP server, check
DHCP Enabled
.
-
If your network uses static IP addresses, do
not check
DHCP Enabled
.
Then complete
the following fields:
Fallback IP Address
= enter switch’s IP
address.
Fallback Subnet Mask
= enter switch’s
subnet.
Fallback Gateway
= enter switch’s
gateway setting.
-
Name
= enter a new username.
-
Password
= enter a new password.
H.
Click
Apply
.
Username and password are case-sensitive.
Permitted characters are a-z, A-Z, 0-9,
underscore, and plus, minus, and equals signs.
7
Front Panel LEDs
LED
Color Status
Power
Yellow ON = switch is receiving power.
PoE
(port number)
Green ON = Power Device (PD) is connected.
OFF = PD is disconnected.
Link/ACT
(port number)
Green
ON = valid network connection.
OFF = no data transmission on port.
Flashing = port is sending or receiving
data.
Click here
Congratulations!
You have successfully
performed a basic installation. For advanced
configuration information, refer to the user
guide.
