Gigabit SFP Hardened Media Converter
13
Installation
This chapter gives step-by-step installation instructions for the Converter.
Selecting a Site for the Equipment
As with any electric device, you should place the equipment where it will not
be subjected to extreme temperatures, humidity, or electromagnetic
interference. Specifically, the site you select should meet the following
requirements:
y
The ambient temperature should be between -40 to 75 degrees Celsius.
y
The relative humidity should be less than 95 percent, non-condensing.
y
Surrounding
electrical
devices should not exceed the electromagnetic
field (RFC) standards.
y
Make sure that the equipment receives adequate ventilation. Do not
block the ventilation holes of the equipment.
y
The power outlet should be within 1.8 meters of the product.
DIN Rail Mounting
y
Fix the DIN rail attachment plate to the back panel of the media
converter.
y
Installation: Place the media converter on the DIN rail from above using
the slot. Push the front of the media converter toward the mounting
surface until it audibly snaps into place.
y
Removal: Pull out the lower edge and then remove the media converter
from the DIN rail.
