5-Port and 8-Port Pocket Size Fast Ethernet Switch
４
User’s Manual
n
Power
This LED comes on when the switch is connected to the power adapter.
o
Port Status
Each port has a LED, indicating the port status.
p
Power Adapter
Connect the supplied AC to DC adapter to the receptacle on
the back of the switch, then plug the cord into a standard AC outlet with
a voltage
range from 100 to 240 VAC.
Table 1: Port Status
LED
State Indication
Steady
The port has established a valid network connection.
LNK stands for LINK.
LNK/
ACT
Flashing
The port is transmitting or receiving data.
ACT stands for ACTIVITY.
Installation
Selecting a Site for the Switch
As with any electronic device, you should place the switch where it will not be
subject to extreme temperatures, humidity, or electromagnetic interference.
Specifically, the site you select should meet the following requirements:
•
The ambient temperature should be between 32 and 113 degrees Fahrenheit (0 to
45 degrees Celsius).
•
The relative humidity should be less than 95 percent, non-condensing.
•
Surrounding electrical devices should not exceed the electromagnetic field (RFC)
standards for IEC 801-3, Level 2 (3V/M) field strength.
•
Make sure that the switch receives adequate ventilation. Do not block the
ventilation holes on the side of the switch or the fan exhaust port on the rear of the
switch.
•
The power outlet should be within 1.8meter (6 feet) of the switch.
