Etesia H124B, Руководство пользователя

Страница: 85 / 98

None of the indicator lights 15 A fuse blown Replace the 15 A fuse (chapter 6.3)
on the dashboard come on Battery connection defective Connect the battery properly (chapter 7.3)
All the indicator lights come on, Not enough diesel Fill up with diesel
the starter is working, but the engine Battery insufficiently charged Recharge the battery (chapter 7.3)
does not start Check the charging current.
The engine is running, but stalls The retractable parts of the cutting Put them back in place correctly.
when the operator system are absent or incorrectly (chapter 5.2)
starts the cutting system mounted
The battery charge light stays on Battery charging circuit defective Contact your dealer
after the engine has started
The engine oil pressure indicator is on Oil level too low Fill up with oil
(after starting the engine)
The hydraulic oil temperature / Hydraulic oil cold Leave the engine to idle for a few minutes
hydraulic filter clogging indicator is on, and then check again
at full engine rate but stops when idling Hydraulic oil filter clogged (oil hot) Replace the hydraulic oil filter
(chapter 6.7)
All the indicator lights comes on All the conditions for safe starting See chapter 5.2
but the starter is not working are not met
The cutting system does not engage All the conditions for safe mowing See chapter 5.2
(with engine running) are not met
The audible warning device is activated The radiator grilles are obstructed. Clean the radiator grilles (chapter 7.1.7)
and the engine temperature indicator is on Lack of coolant
Fill up and check if there are any leaks
The hydraulic oil temperature Temperature of hydraulic oil too high Stop the engine and contact your dealer
/ hydraulic filter clogging indicator is on
at all engine rates.
ABNORMAL OPERATION PROBABLE CAUSE REMEDY
10• POSSIBLE BREAKDOWNS AND THEIR REMEDIES
Consult the table below if you have problems with your ride-on mower. If the problem encountered is not included in
this table or if the remedy suggested does not solve the problem, contact your Dealer, who has the necessary
knowledge and equipment to deal with the problem.
The engine is running, but stalls The retractable parts of the cutting Put them back in place correctly.
when the operator system are absent or
starts the cutting system (H124DN, H124B, incorrectly mounted (H124DN, H124B,
H124DX, H124BX) H124DX, H124BX)
The audible warning device is Full indicator blocked (grass deposits) Remove the grass from around the
activated, the cutting switch (c, photo 28, page 66)
system activated and the basket
empty (H124DN, H124B, H124DX, H124BX)