16
CONNECTION OF REMOTE CONTROLLER WIRING
TO THE WATER HEATER
1. Turn off the power supply to the water heater.
2. Remove the front cover from the water heater. There are 3 screws on the front cover.
3. Put the remote wires through the hole on the bottom of the unit's casing.
4. Remove the plastic cover and connect remote control wires to remote terminals directly.
(There is no polarity in the terminations.)
*DO NOT jump or short-circuit wires. Computer will be damaged.
5. Replace the plastic cover and the front cover. And connect the power plug.
REMOTE CONTROL – CABLE CONNECTIONS
TYPICAL CABLE LAYOUT
1 2 3 4 5 6 7 8
P L A S T I C
C O V E R
R E M O T E C O N T R O L
C A B L E
R E M O T E C O N T R O L
T E R M I N A L
R E M O V E T H E P L A S T I C C O V E R
A N D C O N N E C T T O T E R M I N A L S
D I R E C T L Y B E H I N D T H E C O V E R
Put the remote wires through the hole
on the bottom of the unit's casing.
1 2 3 4 5 6 7 8
M C 1 0 0 - A U 3
S C 1 0 0 - A U 3
F C 1 0 0 W - A U 3