Menu
:
•
Start Up
– Welcome to Eternal Lighting
•
DMX Address and Channel Mode
– Press Enter to move up and down between DMX Addr and CH
also press Enter to save a command.
•
Master/Slave
– Press Up or Down to change the command of Master or Slave, Enter to save the
command. (NOTE: In order to use the IR Remote, put the CUBEecho in Master Mode. The
CUBEecho will not respond to the IR Remote if it is in Slave Mode.)
•
Manual Color Mix
– Press Enter to go through Red, Green, Blue, White, and Amber. Press Up or
Down to adjust color brightness on a scale of 0-255. Enter to save. This color can be found in Color
31.
•
SHND
–Press Up to scroll through options: Color, Sound, and Fade. Enter to select choice.
o
Color
– Pre-set colors 1-31, after color 31 is AUTO change (Speed 1-8). After AUTO, is
Custom Color A – E; Enter make a custom color. You can make 5 custom colors that will be
saved under A through E.
o
Sound
– Sound 1 (auto change when hears sound & Fade when quiet). Sound 2 (Strobe
effect when hears sound & Fade when quiet).
o
Fade
– Color Fade 1 through 10. Fast (1) to slow (10).
•
Boot Time and Work Time
– Current operating time and total run time
•
Battery Capacity
– Indication of Percentage left on the battery
•
LCD Display Time
– Choose to have the Display back lit Full On/10sec-60sec
•
IR INFA
– Enable or Disable
How to use the Wireless Receiver
: Turn the wireless Receiver button to the ON position. There is a
Wireless Indicator that illuminates the colors in the ID Code Selector.
ID Code Selector
– Red (1), Green (2), Yellow (3), Blue (4), Purple (5), Cyan (6), White (7). To change to
ID Code Selector colors, press the small clickable button next to the ID Code Selector. Choose a color, for
example Blue (4), and do the same for all your CUBEecho RGBWA.
Master/Slave
- Have one fixture in Master Mode and the rest of the fixtures in Slave Mode. Turn on the
Receiver button and put all fixtures on same ID Code Color. You now control the Master fixture and all the
Slave fixtures will do what the Master is doing. The Master fixture Wireless Indicator will start blinking
RED (meaning transmitting signal) and all the Slave fixture(s) will start blinking GREEN (meaning
receiving signal).
How to use the XT-Mitter PRO 3.0 with your lights:
To operate the XT-Mitter PRO, you must connect
the XT-Mitter Pro with a DMX cable to a DMX Controller.
To sync the CUBEecho to your XT-Mitter PRO 3.0 transmitter, select the same ID Code color on all the
CUBEecho(s) and select the ID on the XT-Mitter PRO to correspond to the color. Reference the chart
below. Note: Transmitter ID 8, 9, A, B, C, D, E & F is inactive. Only Select 1-7 to coordinate with the
Receiver Color on your fixture.
5
CUBEecho RGBWA Eternal Lighting February 2014
