Etec EXDS217, Руководство по установке

Страница: 4 / 12

Do not attach this A/V Component Stand to any wall with Brick or steel stud construction.
Attaching this mount to wood or concrete walls requires special tools and hardware to
ensure the mount is securely and safely attached to these materials. Brick and concrete
will break or crumble if special concrete drill bits and drill operating speeds are not properly
used. Consult a professional if you are unsure or have any doubts about the safely of the
installation. Personal injury or equipment damage can result if the mount is not properly
installed.
Wood stud walls (Fig 1):
1. Use an electronic stud finder to locate the wall studs. Mark their locations on the wall.
2. Place the
Wall Plate (1) flat against the wall in the desired mounting location, aligning the mounting
holes on the bracket with the studs. Use the
Wall Plate (1)
as a template to mark the mounting holes
on the wall.
3. Use 3/16” (5mm) drill bit to pre-drill holes at least 2.5” inches (65mm) deep at the marked locations.
4. Use the
Long Bolts (A)
and
Long Bolt Washers (C)
to mount the
Wall Plate (1)
to the wall as shown
in Fig. 3. Do not use wall anchors in wood stud walls.
5. Use a level to make sure the Wall Plate (1) is perfectly straight and securely tighten the Long Bolts (A)
using a proper size wrench. Make sure to tighten the top bolt first, then re-check the level before
tightening the bottom bolt.
Step 1: Install the Wall Plate
Read the instructions. Determine the proper location for your wall type. Make sure the mounting location
has enough space for the Glass Shelf (4) and the Wall Plate (1) . Follow the mounting instructions for
wood studs or concrete wall installation.
1
A
4
C
2-1/2” (65mm)