ETC Installation Guide
XDLT 26°/36° Lens Tube Front Lens Kit
XDLT 26°/36° Lens Tube Front Lens Kit
Page 2 of 3
ETC
4.
Place the lens tube on a flat surface with
the front lens facing out.
5.
Use the T20 TORX screwdriver to remove
the four screws that secure the two halves
of the lens tube housing, and then
remove the top half of the lens tube
housing. Note the two nuts that are
nested in the lower lens tube housing,
where you removed the beam focus knob
and screw in step 2.
Remove screws,
and then remove
top housing
Retain
two nuts
6.
Remove the front lens and place it
facedown on a flat, soft surface.
7.
Use the #1 Phillips screwdriver to remove
the three screws and bracket as shown at
right.
8.
Secure the new bracket to the lens with
the provided LOCTITE screws.
Remove old screws and
bracket, and replace with
new screws and bracket
9.
Restore the front lens in the lens tube.
10.
Verify that the two nuts for the beam
focus knob and opposing screw are still
nested in the lower lens tube housing.
Restore
lens
Verify
position
of nuts
