E T C I n s t a l l a t i o n G u i d e
Control Series
Page 3 of 4
SmartClick Switch Station
Surface Mount Using Screws
Use the appropriate screws and anchors for surface or back box mounting.
Screws and anchors are not included.
Step 1: Attach the station to the mounting plate.
Step 2: Align the mounting plate in position and mark the four mounting holes.
Step 3: Drill the required mounting holes.
Step 4: Install anchors (if required).
Step 5: Attach the mounting plate to the wall (hardware provided by others).
Step 6: Attach the faceplate (not included).
Surface Mount Using Tape or Velcro
You can use double-sided tape or Velcro to attach the station. Attaching
material is not included.
Step 1: Attach the station to the mounting plate.
Step 2: Attach two 1.5 inch (4cm) strips of tape or Velcro to the back of the
mounting plate, ensuring they do not extend beyond the edge.
N o t e :
The single gang mounting plate is provided with the station.
A two gang (UA2MP) or three gang (UA3MP) mounting
plate is available separately.
