ETC Source Four PARNel, Руководство пользователя

Страница: 4 / 8

ETC User Manual
Source Four PARNel
Source Four PARNel Page 4 of 8 ETC
Replacing the HPL lamp
A lamp must be installed before you use the fixture.
1: Disconnect power to the fixture before installing the lamp.
2: Loosen the knurled bolt on the back of the lamp housing and pull the
housing out.
3: Holding by the base, remove the HPL lamp from its box.
Note: Verify that the HPL lamp you intend to install is suitable
for your facility’s voltage; 115-, 120-, 230-, and 240-volt
HPL lamps are available. See
HPL lamp table
on
page 2
.
Operating HPL lamps above their rated voltage reduces
lamp life and can cause premature lamp failure.
WARNING:
Unplug the fixture and allow it to cool down before
attempting to change the lamp.
CAUTION: Use caution when installing or replacing any lamp.
When installing/replacing lamp, be sure to point the
lamp away from your face and away from others before
inserting it firmly into the assembly.
This may prevent injuries if the lamp should break.
Note: To avoid premature lamp failure, do not touch the lamp
glass. If you do, clean it carefully with isopropyl alcohol
and a clean lint-free cloth. Allow to dry before
operation.
INCORRECT CORRECT