ETC Setup Guide
Paradigm Rack-mount Repeater
Corporate Headquarters Middleton, WI, USA +1 608 831 4116 London, UK +44 (0)20 8896 1000
Holzkirchen, DE +49 (80 24) 47 00-0 Rome, IT +39 (06) 32 111 683 Hong Kong +852 2799 1220 Paris, FR +33 1 4243 3535
Web
© 2019 Electronic Theatre Controls, Inc. Trademark and patent info:
Product information and specifications subject to change. ETC intends this document to be provided in its entirety.
7182M2261 Rev C Released 2019-07
The Paradigm Rack-mount Repeater adds support for more architectural control stations in the Paradigm
system.
The addition of a Rack-mount Repeater single model extends the station communication bus (LinkConnect)
length by 1,640 ft (500 m) and the Dual Station Repeater extends the station communication bus into two
segments of LinkConnect. Each repeater module type supports an additional 30 Paradigm control stations
or sensors on the topology-free and polarity-independent control network, and provides additional
auxiliary power for up to six Paradigm touchscreens. Station device counts cannot exceed the total capacity
allowed for the Paradigm system.
The installation procedure for the single and dual repeater models is identical.
Installation
1:
Locate the
included
rack mounting hardware kit including the mounting screws and washers.
2:
Use the hardware provided to mount the unit to the mounting rails in your equipment rack.
Power and Control Wiring
All power and control wire terminations are made to the rear panel of the unit.
AC Input
Single phase 115 VAC, 230 VAC, or 240 VAC power input to the IEC connector.
Single and Dual Repeater
models available.
