ETC F-Drive W1 Series, Руководство по установке, Страница: 31 / 44

Chapter 4 27
Chapter 4
Power Up and Control
Power Up Procedure
1. If applicable, check that all third-party load power switches are on.
2. Check the DMX control source to ensure proper installation and termination per the
manufacturer's instructions.
3. Check that all wires are terminated properly and secure in the terminals, if applicable.
4. Apply power at the main circuit breaker.
Note:
On initial power up the F-Drive will perform a routine driver setup. During setup
status panel LEDs may flash. Do not disconnect power to the F-Drive while LEDs are
flashing. Driver setup typically takes several minutes, but may vary depending on
connected loads.
5. Verify LED status on the front of the W1. See Troubleshooting on page 35 .
6. Allocate DMX addresses in ETC Concert software with RDM. See
DMX System Control below
and
RDM Parameters on page 29
.
Identify
An identify command can be sent to a control card or to a channel of an output card. When you
send an identify command to a control card, all LEDs on the control card blink on and off:
500 ms on, 500 ms off until the identify command is ended. When you send an identify
command to a channel, the corresponding LED (1, 2, 3, or 4) on the output card will blink and
fixtures connected to the channel will blink on and off: 500 ms on, 500 ms off until the identify
command is ended. See
RDM Parameters on page 29
.
DMX System Control
You can control the W1 over wired DMX from a lighting console or ETC Concert software.
Concert is available for free download at
etcconnect.com/Concert .
•
F-Drive Series products are compliant with DMX 512-A (ANSI E1.11-2008 (R2013)).
•
DMX loss behavior is configurable via RDM with three options: Go to off, Hold last look, and
Go to full.