18
Source 4
WRD
PAR or PARNel
Position a front lens
1:
There are seven notches cut into the
stippled side of the lens. Position the
lens so that the cluster of three
notches is on top. The center notch of
the cluster aligns with the spring clip
on the lens retainer ring.
2:
The bottom of the lens has a cluster
of four notches. Place the two center
notches behind the tabs at the
bottom of the lens rotator ring.
Cleaning and
maintenance
Clean the fixture
• Use oil-free canned air to clean
the LED domes prior to
installation and prior to storage.
• Use oil-free canned air to clean
the fan and fin stack as part of
regular fixture maintenance.
Store the fixture
• When not installed on the Source 4
WRD
PAR or PARNel Fixture Body, store the
Source 4
WRD
LED in a dust-resistant plastic
bag.
• Store the Source 4
WRD
PAR or PARNel
fixture at temperatures of 5°C (41°F) or
higher.
• If you must store the fixture below 5°C
(41°F), make sure it is in an upright position
as shown to the right. Allow it to warm to
room temperature for a minimum of one
hour before applying power.
CAUTION:
Do not touch or clean LED optic domes with anything
other than oil-free canned air.
Note:
After shipping or storing the fixture below 5°C (41°F),
visually inspect the unit to ensure the low temperatures
have not caused cracking of the LED array.
Top center
notch
Bottom
two center
notches
Fan and
fin stack
Store fixture facing up
