XETK-V2.0 - User’s Guide
43
ETAS
Installation
5
Installation
In this chapter, the hardware installation of the XETK-V2.0 is described.
5.1
Connection to the ECU
5.1.1
XETK-V2.0A/C
Fig. 5-1
XETK-V2.0 Connection to the ECU with Socket/Adapter
For mounting the XETK-V2.0 on the ECU accessories are required (see Fig. 5-1):
• a VertiCal base board
• a QFP or BGA Socket from ST or Freescale, mounted on the ECU printed
circuit board
These accessories need to be ordered separately (refer chapter "Ordering Infor-
mation" on page 94).
CAUTION!
The XETK can be damaged or destroyed!
Some components of the interface board may be damaged or
destroyed by electrostatic discharges. Please keep the board in its
storage package until it is installed.
The board should only be taken from its package, configured, and
installed at a work place that is protected against static discharge.
CAUTION!
Risk of bending or breaking pins of XETK ECU Interface!
When you mount the XETK to the ECU, you must ensure that the
VertiCal connector pins are aligned properly before applying pressure
to the XETK for insertion into the VertiCal Base Board.
CAUTION!
Risk of short circuiting the internal signals of the XETK!
When you mount the XETK to the ECU, you must ensure that the
screws and washers used will not penetrate the XETK printed circuit
board.