ETAS ES5340.2, Руководство пользователя

Страница: 71 / 120

ES5340.2 Electric Drive Simulation Board - User’s Guide 71
ETAS Configuring the Hardware in LABCAR-RTC
5.2 Integration of the Model
The next step consists of configuring the connections to a model.
This requires different measures depending on the type of the model:
• FPGA model
This model is run autonomously on the ES5340.2 Electric Drive Simulation
Board and is configured in LABCAR-OPERATOR.
• Software model
A software model (ASCET, Simulink or C code) is run on the Real-Time PC,
synchronized with the PWM signals from the ECU.
Specifically, the following measures are described:
• "FPGA model" on page 71
– "Adding the FPGA Model in LABCAR-RTC" on page 71
– "Configuring the Model Parameters" on page 73
– "Configuring the Value Ranges" on page 74
– "Determining Default Values" on page 75
– "Configuring Outputs for Current/Voltage Sensors" on page 77
• "Software Model" on page 75
– "Configuring the Inverter Gate Measurement" on page 75
– "Adding Analog Outputs ("Direct out")" on page 77
– "Adding Analog Outputs (for Predicted Values)" on page 78
5.2.1 FPGA model
For configuring the FPGA model, you first have to add the corresponding item.
Adding the FPGA Model in LABCAR-RTC
1. Select the "ES5340-Master" item and click Add
Item .
Note
The FPGA model is an optional component of the ES5340.2 Electric Drive
Simulation Board and must be ordered separately (see "Order Information
and Scope of Delivery" on page 103).