ETAS
Technical Data
BR_XETK-S1.0 - User’s Guide
35
7
Technical Data
This chapter contains information about following topics:
• “System Requirements” on page 35
• “Data Emulation and Measurement Memory” on page 38
• “Configuration” on page 38
• “Automotive Ethernet Interface” on page 39
• “Environmental Conditions” on page 39
• “Power Supply” on page 40
• “Microcontroller Interface” on page 41
• “Test Characteristics” on page 41
• “DAP Timing Characteristics” on page 42
• “Electrical Characteristics” on page 43
• “Pin Assignment” on page 44
• “Mechanical Dimensions” on page 46
7.1
System Requirements
7.1.1
Compatible Hardware
• ES882.1 ECU Interface Module
• ES886.1 ECU Interface Module
• CBEB100.1 Media Converter
• CBEB105.1 Media Converter
7.1.2
PC with one Ethernet Interface
A PC with one open Ethernet interface (1 Gbit/s or 100 Mbit/s, full duplex) with
RJ-45 connection is required. Ethernet interfaces that are implemented with an
additional network card in the PC must feature a 32-bit data bus.
7.1.2.1
Requirement to ensure successful initialization of the module
NOTE
Half Duplex mode and Half Duplex Ethernet interfaces are not supported.
NOTE
It is imperative you disable the function which automatically switches to
power-saving mode on your PC network adapter when there is no data traffic
on the Ethernet interface!
