Let the vacuum cleaner recharge as soon as its suction performance is weaker. In
everyday use of the appliance, let the vacuum cleaner connected to the charger. In this
way the appliance will always be fully loaded. Battery overcharging is not possible. If you
are not present for longer time (more than one day), remove the charger from the electric
socket to save energy.
Vacuuming dry impurities
Select the suitable accessories (
D
– brush adapter for cleaning fine surfaces,
E
– slot
adapter for cleaning corners and narrow gaps). Slide the selected adapter end–to–end
to the hole in the dust container
B
. Remove the adapter in the opposite direction.
Vacuuming wet impurities
Slide the adapter (
F
– rubber scraper) end–to–end to the hole in the dust container
B
.
Push the scraper slightly to the surface that you want to clean and hold the vacuum
cleaner tilted in the angle of about 30 degrees. Make sure that the scraper is constantly in
contact with the surface during vacuum cleaning (Fig. 5).
CAUTION
– When vacuuming wet impurities, the vacuum cleaner cannot be turned with the dust
container upside down, laid down or bent to one side or shaken.
– If the level of the liquid in the container reaches the maximum gauge, stop vacuuming
the liquid.
– After every use of the vacuum cleaner for vacuuming liquids or wet impurities empty
and wipe thoroughly the container, the protector and the filter before you put it in the
holder.
Emptying the dust container
If the amount of impurities in the container reaches the
MAX
gauge, it has to be emptied.
Release locking of the container
B
by pressing the
A3
button and remove it from the
vacuum cleaner by tilting (Fig. 7). Turn and pull out the HEPA filter
B1
and the HEPA
filter protector
B2
from the container (Fig. 8), then place the container over a dustbin and
empty it into common municipal waste (Fig. 9). Slide the protector and the filter back to the
container end–to–end. Put the container to the vacuum cleaner in the opposite direction
and secure it by snapping in the locking button
A3
. For sanitary reasons we recommend
emptying the container outside housing premises.
Cleaning the dust
container and cleaning the HEPA filter
After about 5 emptying of the container we recommend complete cleaning of the suction
system from the settled dust. Tap the dust out of the HEPA filter over a dustbin or to clean
the filter through a blowing (we recommend the filter cleaning outside of living area for
hygiene reasons). Clean all parts (i.e. the container and the filter protector) in running
lukewarm water (e.g. using a cloth or a soft brush) and let it dry completely (Fig. 10).
Re–assemble individual parts in the opposite direction after it is completely dry.
GB
20 / 34