eta Steam Master 3234, Инструкция по эксплуатации, Страница: 27 / 56

If the above-described set is used, mopping/floor nozzle D may be independently
(cleaning dry surfaces) or added with the mopping textile
F3
put on (surfaces designed for
simultaneous vacuuming and mopping parquets and other hard floors e.g. floating floors,
tiles, linoleum, etc.)
B) HANDHELD STEAM CLEANER (Fig. 1b)
If you are going to use the appliance as a handheld steam cleaner, remove the steam unit A
from the extension adapter
B
by pressing the lock button
B2
, (Fig. 2)
Accessories assembly options
Steam cleaner may be used in many assembly variants, keeping the following rules:
– Concentrating nozzle E1 and extension hose E2 may only be installed on steam nozzle
A6 . Both adapters can be used either separately, or concentrating nozzlewith the
accessories E3 – E5 mounted.
– Accessories E3 – E5 can be put on the concentrating nozzle E1 .
How to assemble the accessories
(Fig. 1b)
Concentrating nozzle E1, extension hose E2
Can be put on the steam nozzle A6 by simple sliding it down completely, and securing in
place (clicking). Apply reverse procedure to remove. First you have to press the security lock
lever on the respective adapter.
Accessories E3 – E5
The accessories can be mounted on the concentrating nozzle E1 , by sliding it down
completely. Apply reverse procedure to remove.
Attention
Before using the appliance, check all the components if they are properly connected
and assembled! Make sure that the contact surfaces and sealing elements are clean
and undamaged.
Water filling (Fig. 3)
When filling water, make sure that the appliance is disconnected from the mains. Press the
lock button A2 , remove the container A4 from the steam unit A and pulling it out. If the water
filter A5 must be replaced, pull it out from the steam cleaner body (see the Fig. 5). Remove
the water tank plug
A8
from the tank. Fill the tank with water or demineralised water. Do not
exceed the maximum permitted volume of water (i .e. 349 ml). Put the plug in place. Install
the assembled tank on the steam unit A in a reverse way, end-to-end, which is accompanied
by characteristic sound (clicking).
Attention
– Never use the appliance without the water filter A5 properly fixed.
– The steel ball of water tank A4 at the end of the hose must permanently and freely
move below the water level. If it gets stuck, free it by shaking the cleaner.
IV. STEAM CLEANER USE
First choose the appliance assembly variant, and then add/remove the respective
components and accessories of the appliance as needed. Unwind the power cord A9 from
the extension adapter holder B3 / D3 , and plug the power cord in a wall socket.
GB
27 / 50