V. MAINTENANCE
Store the vacuum cleane
r at a
dry place, far enough from heat sources (e.g.
fireplace, stove, heating
element
) and protect it from weather conditions (e.g.
rain, sunshine
). Treat surface of the appliance
with a soft and damp cloth, do not use coarse and aggressive detergents! Store the appliance properly
cleaned at a dry, dust-free place out of reach of children and incapacitated people.
Floor nozzle, parquet nozzle, brush
After any vacuuming it is recommended to check visually the brushes or collectors for possible
impurities. If there are some impurities, remove them.
Cleaning the TURBO nozzle C8
(pic. 21)
Cut the threads and hairs with scissors. Turn on the vacuum cleaner. The cleaner vacuums the
cut hairs and threads. In case hairs or threads got tangled up around the attachment of the brush
cylinder and cannot be removed with the above-mentioned steps, it is necessary to remove them
with a suitable tool (e.g. tweezers). The front cover of the brush cylinder (depending on model) can
be removed for easier and more comfortable maintenance by releasing the arrest latches on its
sides and sliding it out. At the same time, make sure no dirt is stuck on the inner side of the nozzle
(i.e. turbine). Release the two arrest latches on the bottom side of the nozzle in the direction of the
arrow and remove the cover. Clean the space with a suitable tool (e.g. tweezers). Insert the covers
back into the nozzle reversely and close it with by folding it up (you hear an audible click).
Cleaning the narrow TURBO nozzle C9
If hair or threads are twisted around the mounting of the drive shaft and if they cannot be removed
in the way described above, the impurities have to be removed by dismantling the nozzles.
At the same time make sure the inside of the nozzle is free of dust and dirt. You may find an arrest
ring on the back side of the nozzle at its connection to the suction pipe, by which you can unlock
and remove its cover (turn it counter-clockwise in the direction of UNLOCK). Clean the spot with
a suitable tool (e.g. tweezers). You may remove the turbine ring for easier cleaning. Place on
it the driving belt before putting it back (if you have removed the ring) and only then put it back
in its place. Put the cover on the nozzle reversely, close it by folding it on and secure it with the
arrest ring (turning clockwise in direction of LOCK).
DermoPet cleaning
After each use make a visual control whether the brushes or combs do not have any impurities.
If you see any impurities, clean the nozzle or remove it, wash and degrease, or disinfect with
a disinfectant solution (eg Ajatin, Chloramine).
vI
. TROUBLESHOOTING
Problem
Cause
Solution
Motor won‘t start
Power supply not connected
Check the cord, plug and the socket
button is not switched on
Push button
Lid cannot be closed -
safety lock activated
Dust filter inserted incorrectly
in the holder / adapter
Check / repair fastening of the
cardboard front in the holder / adapter
Suction output is not
sufficient
Regulation in MIN position
Set regulation to MAX.
Open suction
Close the hole in the hose handle
Dust filter full
Replace the filter
Clogged micro-filters
Clean or replace the micro-filters
Nozzle/ suction hose/tube or
accessories is clogged
Remove blocking objects
30
GB
/ 48
Содержание MANOA
Страница 2: ...1 C8 D5 D D2 D3 D4 D1 C7 C6 C5 C4 C9 2 48 ...
Страница 4: ...14 16 15 19 18 20 17 21 4 48 ...