eta Lorinka 6599, Руководство пользователя

Страница: 16 / 32

III. INSTRUCTIONS FOR USE
Fill the kettle with clean cold water up to max., turn it on and let the water boil before first
use. Then Pour the water out and repeat the process several times (at least five times).
You will boil the kettle out properly this way and get rid of potential taste of plastic. If you feel
like you have aftertaste of plastic from boiled water, we recommend to repeat the procedure
according to the instructions in the paragraph IV. MAINTENANCE – cleaning the kettle.
Another recommendation is to leave the empty kettle open for 24 hours.
APPLICATIONS
Open the lid A5 by pressing the lock button A6 . Fill the kettle with drinking water. Close the
lid by snapping. Put the electric kettle on the stand and turn it to the I position by the A1
button. Function of the electric kettle is signaled with the control light
A2
. After boiling the
appliance switches off automatically. Before reaching the boiling point, you can switch off the
appliance by turning the A1 button to the 0 position.
ATTENTION
– When heating water, the lid must be closed, otherwise the kettle will not turn OFF.
– In bigger tilting of the electric kettle backwards, particularly when it is filled up to
maximum, water can flow out from the electric kettle in the bottom part of the kettle.
This does not affect safety or other functions and it does not mean any failure of the
electric kettle. In the case of tilting the electric kettle with hot water there is a risk of
scalding. Therefore do not tilt the electric kettle.
– Recommendation: When the kettle is not used, do not place it on the stand connected
to the mains. If you are going not to use the kettle for a long time, unplug the power
cord from the wall socket.
– If the kettle was removed from the stand during boiling, remains in ON position.
This means that if you put it back on the stand, it will immediately continue in heating.
IV. MAINTENANCE
Unplug the appliance from power supply by taking the fork of the power cord out of the
socket! Clean the kettle only when it is cooled down! Do not use rough and aggressive
detergents (e.g. sharp objects, scrapers, diluting agents or other solvents)! The casing
of the electric kettle is made of top-quality plastic material and the heating bottom is made of
top-quality stainless steel, but in common use, impurities from water get stuck on them (water
scale), particularly above the heating element. It is not rust or another material defect
of the kettle container and the appliance is not subject to a complaint for this reason.
Cleaning the kettle
Pour about 50 g citric acid to the kettle with the water scale sediment. Fill the kettle to about one
half and mix. After it dissolves, fill the kettle to 3/4 of the maximum amount of water. Place the
electric kettle on the stand and turn it on. Before boiling, turn off the kettle, let the solution take
effect for about 10 minutes and then pour it out. Clean the kettle thoroughly with clean water.
Repeat the whole procedure if the kettle is too soiled. Clean the electric kettle regularly!
Cleaning the sieve
(
A7
)
Take the sieve from the kettle. Clean it from possible sediments in running water using a fine
brush. Then put the sieve back in the opposite way.
16
GB
/ 27