eta LIMET 1033, Инструкция по эксплуатации

Страница: 15 / 32

– After finishing work and before cleaning, always switch off the appliance and disconnect it
from power supply by taking the power cord connector out of the electric socket.
– Never immerse the driving unit in water nor wash it under water flush!
– Use the appliance only with the accessories designed for this type. Using other
accessories can be dangerous for the operator.
– Use the appliance only in working position in places where there is no fear of tipping over
and within sufficient distance from thermal sources (e.g. kitchen-range, stove, gridiron,
etc. ) and wet surfaces ( kitchen sink, wash-basin, etc. ).
– This appliance is not intended for outdoor use.
– Do not place any objects on the appliance.
– It is not permissible to adjust the surface of the appliance in any way (e.g. by means of
self-adhesive wall-paper, foil, etc.)!
– Make sure that hair or loose clothes do not get into the accessories to avoid risk of them
tangling into the mixing blade.
– If the propulsion unit is operating, do not remove the accessories.
– Do not put the appliance into bodily holes.
– Do not process frozen fruit or fruit too hard (e.g. pineapple, mango, etc.)
– If the pulp of the processed fruit begins to collect on the sieve excessively, turn off the
appliance and clean the sieve (e.g. under running water).
– Make sure the supply cord does not get in contact with the rotating parts of the appliance.
– Supply cord must not be damaged by sharp or hot subjects, by open flame and it must not
be immersed in water.
– If you need to use extension cable it must not be damaged and it must comply with the
valid standards.
– Make sure that the power cord does not hang over the edge of the working table where
children could reach it.
– Check the condition of the supply cord regularly.
– Do not wind the power cord around the appliance; this will extend its life.
– Never use the appliance for other scope than for which it was intended and described in
the present instructions!
– The manufacturer does not answer for damages caused by wrong use of the appliance
and its accessories (e.g. devaluation of foodstuffs, fire ) and he does not guarantee for
the appliance if the above stated security advices have not been observed.
II. FEATURES OF THE DEVICE (pic. 1)
A – propulsion unit C
–
sieve
A1 – propulsion shaft D1 – press spike
A2 – supply cord D2 – spike attachment
B – dish E – lid
B1 – closable drain
III . PREPARATION FOR USE
Remove all packaging material, remove the juicer. Remove any possible adhesion foils,
stick-on labels or paper from the appliance. Wash all parts that will come in touch with food
in hot water with soap, rinse them thoroughly with clean water and wipe dry or let dry before
first use. The appliance is now ready for use. Select the amount of processed ingredients so
that the maximum content of the inside container does not exceed. It is necessary to divide
bigger amounts of processed ingredients into several portions and check the contents of the
container continuously.
15
GB
/ 30