eta Galanto, Инструкция по эксплуатации, Страница: 20 / 52

Dust filter replacement
Lift the lid of the vacuum cleaner A2 (Fig. 12) by pushing the lock A11 . Pull out the
dust filter lock A12 from the guide ribs of the holder A15 (Fig. 13) and dispose of it with
common municipal waste. Slide the front part of the dust filter (in the direction of the
arrow) to the holder in the suction space of the vacuum cleaner and push it to the
maximum position. Close the lid of the vacuum cleaner by snapping it.
Replacing micro-filters
After filling about 5 dust filters, micro-filters must be replaced with new ones. Dispose of
the used dust filter and the micro-filters with common municipal waste. You can buy
replacement filters and micro-filters in electro store chain.
Suction micro-filter
Deflect the sealing rubber and hold the micro-filter A13 and remove it by pulling it
upwards (Fig. 14). Put in the new micro-filter in the opposite direction behind the guide
ribs and slide it in the suction area of the vacuum cleaner to the maximum position. Check
whether the micro-filter is properly inserted under the sealing rubber in the suction area of
the vacuum cleaner.
Exhaust micro-filter
Push the lock in the upper part of the exhaust cover A8 , then lift off the cover and remove
it from the vacuum cleaner (Fig. 15). Pull out the micro-filter A7 . Put in the new micro-filter
back to the vacuum cleaner in the opposite direction. Insert the lugs on the back cover
into two holes in the vacuum cleaner cover and click the cover shut.
Storing accessories
Put one of the accessories (the crevice nozzle or the brush) to the holder B4 that you
fasten to the suction hose. The remaining accessories, the floor nozzle, the suction tubes
and the hose can be dismantled again or left assembled and hung on the back side or on
the bottom of the vacuum cleaner
A9 into the storage position. For better stability, slide
the individual parts of the tube inside each other so that the tube is as short as possible.
When storing, always set the floor nozzle to the carpet position (i.e. with the brush
retracted); thus you will prevent bending of the bristles.
V. MAINTENANCE
Store the vacuum cleaner at a dry place, far enough from heat sources (e.g. fireplace,
stove, heating element ) and protect it against weather conditions (e.g. rain, sunshine ).
Treat the appliance surface with a soft damp cloth, do not use coarse and aggressive
detergents! For failure-free operation of the vacuum cleaner we recommend checking the
20
G B
CAUTION
- Micro-filters are not designed for washing.
- The safety lock does not allow closing of the lid of the vacuum cleaner if you forget to
insert a new dust filter.
- Failure to replace micro-filters may lead to defect of the vacuum cleaner!
- Take care that the binding surfaces and sealing elements are functional.
- You can buy a replacement dust filter and micro-filters in the elektro shop chain.
0474_CZ,SK,GB,H,RU,LT_6:gate 16.6.2010 15:05 Stránka 20