eta ETA832290000, Руководство пользователя

Страница: 13 / 32

GB
13 / 27
– For additional protection we recommend installation of current protection (RCD) with the nominal
release current not exceeding 30 mA . Ask a control technician or an electrician for advice.
– Always unplug the appliance from power supply if you leave it unattended and before
assembly, disassembly or cleaning.
– CAUTION – Do not use the appliance with a program, time switch or any other part that
turns the appliance on automatically as there is a risk of fire if the appliance is not covered
or placed properly.
– The appliance is intended for use in households only and for similar use!
It is not designed for use in hair salons or for similar commercial use!
– Do not plug the power cord in the electrical socket and do not unplug it with wet
hands or by pulling the power cord!
– Do not leave the appliance in operation unattended!
– Switch off the appliance right after its use, unplug it from power supply and let it cool down.
Then put it on a safe dry place, out of reach of children.
– Holes for air ventilation must not be covered. Also, do not put the appliance in the “on”
position on soft surfaces (e. g. bed, towels, sheets, carpet) , the duct could get covered.
– When the appliance is overheated, the automatic heat fuse is activated and it disconnects
power supply. If it happens, switch off the appliance and unplug it from the socket.
Remove possible visible obstacles preventing air flow and let the appliance cool down.
– Never put the power cord on hot surfaces and never let it hang over table edge or worktop
edge. If the cord is caught or pulled, e.g. by children, the appliance may overturn and fall
down, causing a serious injury!
– The power cord must not be damaged with sharp or hot objects, open fire, it must not
be sunk into water or bent over sharp edges.
– Only use this appliance for the purpose it was designed for, as specified in this manual.
Never use the appliance for any other purpose.
– The producer does not guarantee any loss caused by improper handling of the appliance and
its accessories (e. g. electrical accident, fire, burn, hair damage ) and its guarantee for the
appliance does not apply in the case of non–compliance with the safety instructions above.
II. FEATURES OF THE DEVICE (FIG. 1)
A – propulsion unit
A1 – temperature and air flow intensity switch
position „ “ – off
position „ “ – minimal temperature and maximal air flow intensity
position „ “ – maximal temperature and low air flow intensity
position „ “ – maximal temperature and air flow intensity
A2 – brush
A3 – cold top
A4 – turning joint of the power supply
A5 – supply cord
A6 – loop for hanging
B – travel case
III. INSTRUCTIONS FOR USE
Remove all packaging material and remove the unit with brush. Plug the fork
of the power supply A5 into the el. socket. Turn A1 temperature switch to the required
temperature and air flow intensity. Turn off the device by positioning A1 to „ “.