eta Esmira, Руководство пользователя

Страница: 26 / 52

Keep the position of the iron for pouring water in it. Put the iron to the rest position (Fig.
7) and set the regulation wheel H to the maximum position. Plug power cord M into a socket.
When the control light G switch off, disconnect the iron from the electric power. Hold the
iron in the horizontal position over a sink. Press the SELF CLEAN button repeatedly (two
to three times), each time for about 5 seconds. Then wait till water stops going out from the
ironing plate. If the iron still contains a lot of impurities, repeat the procedure while pushing
the intensive steaming button between individual pushing of the
SELF-CLEAN
button. After
completing the cleaning, plug the iron into the electric power, set the selected program and
then iron a clean piece of cotton cloth so that the ironing plate is cleaned. Clean the ironing
plate using the SELF CLEAN function continuously (about once a month).
Storage
After finishing ironing, pour out the unused water from the container (be careful, it can be
hot), or let the rest of the water evaporate and let the iron cool down. Then turn regulator D
to position (steam switched off). Put the iron to the rest position (Fig. 8) out of reach of
children and incapacitated persons.
IV. MAINTENANCE
Before every maintenance, unplug the iron from power supply by taking the fork
of the power cord out of the socket! Do not use rough and aggressive detergents
(e.g. sharp objects, peelers, pot scourers, caustic agents for cleaning or other
solvents). Wipe the entire iron with a wet cloth in the cooled state and dry up. If brown
film is created on the ironing plate (e.g. when ironing starched laundry), you can remove
the film by a detergent containing fine sand. The iron is equipped with a permanent
decalcification system
ANTI CALC
that does not require maintenance. But the system
cannot fully prevent creation of calcareous sediments.
V. TROUBLESHOOTING
Problem Cause Solution
Iron is not heated. Power supply not connected Check the cord, plug and the socket
Thermostat regulation wheel is set
on the minimal temperature
Set the wheel to position • / •• / ••• or
MAX
Iron does not
create steam
There is no water in the container Pour water into the container
Steaming regulator is in
position
Move the regulator into the steaming
position
Low temperature is set for
activating the DRIP-STOP
function
Use the regulation wheel to set
a temperature, during which you can
use steaming and wait till the iron is
heated for using it
Iron does not
create steam
shock
Low temperature is set for
activating DRIP-STOP function
Use the regulation wheel to set
a temperature, during which you can
use steaming and wait till the iron is
heated for using it
The function of steam shock was
used too often during a short
period of time
Let the iron heat and wait for a while
before using the electric shock
function again
26
GB
/ 46