eta BLADE MASTER 0341 90000, Инструкция по эксплуатации

Страница: 19 / 48

EN
19 / 41
WARNING
– To power the appliance, only use a source of safe low voltage of 5V which complies
with applicable standards (mobile phone chargers with a micro USB connector with
double insulation are suitable).
– Do not use USB ports on other devices (e.g. computers, laptops, tablets, mobile phones, etc.)
to power the appliance. Such devices may not be dimensioned for the current consumption of
the appliance and it could damage them.
II. DESCRIPTION OF THE APPLIANCE AND ITS ACCESSORIES (fig. 1)
A – Trimmer
A1 – ON/OFF/lock switch
A2 – Socket for charging
A3 – LED indicator
B – Combs
B1 – Universal hair-trimming adapter
B2 – Adjustable comb adapter 1-10 mm
(compatible with universal hair-trimming adapter B1 )
B3 – Beard trimming adapter
B4 – Body hair-removing adapter
B5 –Nose, ear and eyebrow hair removing adapter
C – Blade lubrication oil
D – Brush
E – USB cabel
F – Practical storage tray for the appliance and accessories
III. INSTRUCTIONS FOR USE
Before you can use the appliance, its batteries must be charged. The operation time for one charge
depends on the attachment used and workload. Attachment is around 60 minutes.
To Charge/Recharge
– Fully charge Clipper before using for the first time or after non- use for a long period of time.
– Battery performance is best if you recharge only when the battery is (almost) completely empty.
– Charging or recharging at temperatures below 10°C or higher than 40°C adversely
affects lifespan of the battery.
– Continuously recharging Clipper will reduce lifespan of battery.
LED indicator (A3)
Red light Charging
Green light Charging completed
1) Be certain Clipper is OFF .
2) Connect the trimmer to the adapter and plug the adapter to the mains.
3) It will take approximately 2 hours to fully charge the Clipper. Do not exceed the set time of charging!
4) After charging, unplug the adaptor from the mains first and only then unplug the connector from
the appliance.