eta 7333, Инструкция по эксплуатации, Страница: 12 / 32

- When handling the hair straightener, protect the power lead against contact with
the hot surface of the plates, or other sources of heat.
- Switch off the hair straightener right after its use, unplug it from power supply and let it
cool down. Then put it on a safe dry place, out of reach of children.
- Do not wind the power cord around the appliance; this will extend life of the power cord.
- If the power cord of the appliance is corrupted, it has to be replaced by the producer, its
service technician or a similarly qualified person so as to prevent dangerous situations.
- Never use the appliance for any other purpose than for that described in these
instructions for use!
- The manufacturer is not responsible for damage caused by improper handling of the
appliance (e.g. fire, burning, hair damage, etc. ) and its guarantee does not cover the
appliance in the case of failure to comply with the safety warning above.
II. DESCRIPTION OF THE APPLIANCE (Fig. 1)
A – hair straightener
A1 – ON/OFF button A5 – grooves for easy hair curling
A2 – temperature regulator A6 – turning joint of power cord
A3 – control light A7 – power cord
A4 – heating plates A8 – hanging loop
B – case
III. INSTRUCTIONS FOR USE
Remove all the packing material and take out the hair straightener. Put the hair
straightener on suitable even surface (see par.
I. SAFETY SHEET ). Plug power cord
connector A7 to an electric socket. Set regulator A2 to the required temperature
(140, 160, 180, 200 or 220 °C) according to the type of hair. Switch on the hair
straightener by pressing
A1 button. Control light A3 will turn red, which signals heating of
the plates. As soon as the set temperature is set, control light A3 will turn green. Then the
temperature will be kept automatically. Switch off the appliance after use by pushing A1
button (control light A3 will go out) and let it cool down before putting it into the case.
Note
You can change temperature by regulator A2 during hair styling. If you set higher
temperature, wait till the control light turns green. If you set lower temperature, wait for
a couple of minutes before the temperature drops. Then you can continue hair styling.
Temperature and type of hair
Low temperature
(140 – 160 °C) – for fine, bleached or damaged hair
Medium temperature (160 – 200 °C) – for normal and wavy hair
High temperature (200 – 220 °C) – for strong, rough and curly hair
Hair straightening
Use the hair straightener for washed and dried or slightly damp hair, never for wet hair.
Before using the hair straightener, comb the hair so that it is not dishevelled. First start to
style the lower hair. When the style hair, do not put locks of hair that are too thick between
the plates. Divide a lock in about 5 cm of its width and put it into an open hair
straightener. Then close the hair straightener by pushing and move it slowly on the lock
from roots towards hair tips. You can curl the tips thanks to round edges of plates
12
GB