eta 239590000E, Инструкция по эксплуатации

Страница: 89 / 164

EN
EN - 89
Dishwasher Features
11 12
1
2
3
4
5
7
8
9
6
10
Front view
Back view
1. Top spray arm
2. Cutlery rack
3. Upper basket
4. Inner pipe
5. Lower basket
6. Salt container
7. Dispenser
8. Cup shelf
9. Spray arms
10. Filter assembly
11. Inlet pipe connector
12. Drain pipe
IV. PRIOR USING FOR THE FIRST TIME
Before using your dishwasher for the first time
• Set the water softener
• Add 1.5 Kg dishwasher salt and then full fill the salt container with water
• Fill the rinse aid dispenser
• Fill in detergent
A. WATER SOFTENER
• The water softener must be set manually, using the water hardness dial .
• The water softener is designed to remove minerals and salts from the water, which would
have a detrimental or adverse effect on the operation of the appliance. The higher the
content of these minerals and salts, the harder your water is. The softener should be
adjusted according to the hardness of the water in your area. Your local Water Authority
can advise you on the hardness of the water in your area.
Adjusting Salt Consumption
The dishwasher is designed to allow for adjustment in the amount of salt consumed based
on the hardness of the water used. This is intended to optimise and customise the level of
salt consumption.
1. Open the door ,switch on the appliance by pressing ON / OFF button
2. Press the PROGRAM button for more than 5 seconds to start the water softener set
model within 60 seconds after the appliance was switched on (The Saltand Rinse aid
warning lights will be on periodically when it get in the set model).
3. Press the
PROGRAM
button to select the proper set according to your local
environment, the sets will change in the following sequence: H1>H2>H3>H4>H5>H6>H1
4. Press the On/Off button to end the set up model.