ESX Vision VX5000 PRO, Руководство пользователя

Страница: 18 / 28

18
ENGLISH
INPUT
SENS.
HIGH VOLTAGE
1.0 - 9.0 V
LOW VOLTAGE
0.4 - 3.6 V
ELECTRICAL INTERCONNECTION
BEFORE CONNECTING
For the professional installation of a sound system, car audio retail stores offers appropriate wiring kits. Ensure
a sufficient profile section and a suitable fuse rating and the conductivity of the cables when you purchase
your wiring kit. Clean and remove rust-streaked and oxidized areas on the contact points of the battery and the
ground connection. Make sure that all screws are fixed tight after the installation, because loose connections
cause malfunctions, insufficient power supply or interferences.
Not included in the scope of delivery
+12V
Connect the 12 volt terminal of the amplifier to the positive pole of the power capacitor by using a suit-
able cable (refer to the table on the next page). Then connect the positive pole of the power capacitor
to the 12 volt positive pole of the vehicle battery.
ATTENTION: Use for the connection a sufficiently dimensioned cable of at least Ø 50 mm
2
with a total
length of max. 2 meters. If you use a longer cable, the cross-section must be correspondingly larger.
Use a very short cable length from the amplifier to the power capacitor, which should be mounted
close as possible to the amplifier.
1
REM
Connect the turn-on signal from the head unit / car radio (REM) with the REM terminal of the power
capacitor. Then connect the REM terminal of the power capacitor with the REM terminal of the ampli-
fier. Hereby the amplifier and the power capacitor are turning on or off with the head unit / car radio.
Use therefor a suitable cable with a sufficient cross section (0,5 mm
2
).
2
1 2 3
< 30 cm >
Turn-on cable to the
head unit (car radio)
Min. Ø 50 mm
2
with a
max. total length of 2.0 m
Min. Ø 50 mm
2
with a
max. total length of 2.0 m
ADDITIONAL
BATTERY
< 15 cm >
4
5 6