Eswood IW-3N, Руководство по эксплуатации оборудования, Страница: 7 / 17

ESWOOD OPERATING MANUAL IW-3N June 2011
7
I
NITIAL START
-
UP PROCEDURE
5
1.
Unwind the clear coiled detergent tube and place the free end in a
container of commercial grade glass washing detergent. Use only products
designed for commercial glass washing and in accordance with the
manufacturers recommendations.
2.
Open the hot and (if connected) cold water supplies to the machine. Turn
the selector switch to either of the available cycles, and then turn the power
on. The break tank will then fill with hot water. The red “Power On” light
and the amber “Indicator Cycle” light will also illuminate.
3.
With the break tank full, turn the switch on the front of the break tank to
OPERATE POSITION . (See photo page 6).
Failure to observe the above may cause damage to the element which
is not covered under warranty.
The “low Temp Wait” light will illuminate and the machine will begin to heat
the water to the required 82 degrees C. When the green “Ready” light
illuminates, then the machine is ready for use.
4.
Check that the door is closed.
5.
Provide that the green “Ready” light is on, press the green button to start
the machine. Whilst the machine is running, the amber “Indicator Cycle”
light will flash.
6.
Check that the correct final rinse (hot or cold) for the selected cycle has
been sprayed into the chamber, by either feeling the temperature with the
flat of a hand on the cabinet exterior, or checking the cabinet interior
immediately the cycle has ended. Check the other cycle in the same way.
7.
Check for leaks and refit the lower panel.