Eswood B42GN, Руководство по эксплуатации оборудования

Страница: 8 / 18

ESWOOD OPERATING MANUAL B42N/June 2011
8
W
ASHING
O
PERATION
5
1.
Check the level of detergent and fill when necessary. Also check
that the pump intake filter is clean and in place over tank intake
hole and the overflow tube is placed into the drain flange at
bottom of tank.
2.
Close the door, turn the rotary switch to “FILL” , the fill light
illuminates till filling is complete.
3.
When the machine has finished filling, open the door and check
that the water is up to the overflow level (approx. 30mm from
tank shelf) . The wash tank heating is actuated automatically.
Place the strainer trays in place within the tank.
4.
Select the hot cycle on the rotary switch (see page 7 )according
to the degree of soiling. For heavy soiled glasses use the scrub
cycle, use the hot and cold cycle if glasses need to be cooled
after washing.
5.
Place the dirty glasses upside down in the glass rack slice the
rack into the machine, close the door and press the “START”
button. The cycle light (see Page 7 ) pulsates during the cycle
till complete.
Note that the cycle will not begin until the water in the booster
has reached 82
O
C.to ensure correct temp of operation. Warning
light “low temp” (See page 7) will indicate if the temperature is
low.
To avoid breakages when washing stem-ware, it is advisable to
use a compartmented glass rack. Your supplier can advise you
on the selection of an appropriate rack.
6. When the washing is finished, open the door and remove the
clean rack. To wash another rack repeat from step 5.