Esu LokPilot Fx micro V3.0, Руководство пользователя

Страница: 68 / 72

68
21.2. M4-Decoder
Value settings, which can be reached via Motorola programming.
Important: All values have to be multiplied by „ 4“, if used together with a Central Station or the ESU LokProgrammer, as a value
setting of 0 - 255 is adequate!!!
CV Name Description Range Value
01 Engine address Address of engine 01 - 80 03
02 Starting voltage determines the minimum speed 01 - 63 03
03 Acceleration This value multiplied by 0.25 is the time from stop to 01 - 63 16
maximum speed
04 Deceleration This value multiplied by 0.25 is the time from maximum speed to stop 01 - 63 12
05 Maximum speed Maximum speed of loco 01 - 63 63
08 Factory reset Resets decoder to default values - 8
53 Load control Determines the back EMF voltage that the motor should supply at maximum 01 - 63 45
parameter 1 speed. The more efficient the motor, the higher this value may be. Reduce
(control reference) this value if the engine does not reach its designed maximum speed.
54 Load control „K-component“ of the internal PI-controller. 01 - 63 32
Parameter 2 Determines how strongly load control effects. The higher the value, the stronger
the decoder controls the motor.
55 Load control „I-component“ of the internal PI-controller. 01 - 63 24
Parameter 3 The monumentum of the motor determines parameter 3.
Motors with large flywheels or large diameter require a smaller value.
56 Load control influence 0 – 100 % 01 - 63 63
Determines how strongly load control is active.
78 Starting voltage in analogue mode AC 01 - 63 25
79 Maximum speed in analogue mode AC 01 - 63 63
List of all supported CVs (M4-Decoder)