Summa Series Servodrive Product Manual
Basic Settings
Document Version: V1.01
(Dec, 2019)
© 2019 ESTUN Automation Co., Ltd. All right reserved.
4-1
Chapter 4
Basic Settings
You can implement the functions of parameter setting, display, monitoring, alarm, adjustment, etc. of the
Drive in the following two ways.
Use the Panel Operator of the Drive
Use the ESView V4 (
Recommended
)
4.1
Panel Operator
4.1.1
Key Names and Functions
There is a Panel Operator on the front of the Drive, as is shown in Figure 4-1.
Figure 4-1
Diagram of Panel Operator
SYS RUN ERR
POWER
Operation Indicators
Five 7-segment LEDs
Keys
Power Indicator Light Strip
The names and functions of the keys on the Panel Operator are as follows.
Keys
Function
M
Press [
M
] key to select a basic mode, such as the status display mode, utility
function mode, parameter setting mode, or monitor mode.
▲
Press [
▲
] Key to increase the set value.
▼
Press [
▼
] Key to decrease the set value.
◀
Data setting key
To display parameter setting and set value.
To shift to the next digit on the left.
