•
Have the client turn for access to the side, outside and inside of the arm
and side of the neck. Have them keep turning in the same direction to do
their back.
•
Continue down the back of the legs. Where necessary, have the client
bend or stretch to eliminate folds or creases under the buttocks, breasts or
other areas necessary to allow an even application.
•
Once you are confident that you have covered all areas of the client (face,
chest, stomach, back, arms and legs) it is generally a good idea to apply an
additional spray to the face.
•
Have the client turn so you can examine all areas for sparse or excess
coverage. If the solution is running, you should blot it with a towel and
spray a small amount to even out the application.
•
Once you are confident that you have an even application, you can go over
the client again without triggering the gun – the dry air from the gun will
accelerate the drying process. The client should then avoid lowering their
arms against their sides or pressing their thighs together until thoroughly
dry.
Tip
: if the client feels any stickiness, you may use a fat makeup brush dripped in
'cornstarch based' baby powder to lightly dab the sticky areas. (Do NOT use
talcum powder!)
After Use
When you have done all the tanning for the day, rinse the gun fluid cup with clear
water, then pour in about 2 or 3 ounces of cleaning fluid into the cup and spray
that through the gun into a sink or other receptacle until you are confident that
all of the solution has been washed from the gun.
Next, examine the front nozzle of the gun to ensure that there is no build-up of
product that could obstruct or diminish the fine atomisation of product on the
next use. If necessary, clean the nozzle with the cleaning solution and a small
brush such as a tooth brush or nail brush.
Next, remove the fluid cup, and spray until only dry air comes from the gun. Wipe
off the outside of the gun, rinse out the fluid cup, and you are now done with the
gun for the day.
Finally, check the intake air filter on the turbine air pump to make certain that it is
free of lint, hair, tanning solution residue or other obstructions that could choke
the free flow of air into the pump.